If you are a law enforcement or corrections officer, please complete this questionnaire to the best of your ability. Your responses will help identify needs and requirements for the development of an ASTM International standard specification for duty gloves.

Question Title

* 1. What is your primary job function?

Question Title

* 2. Indicate the state where you work.

Question Title

* 3. What gloves do you current wear the most?

Question Title

* 4. Please answer the following the questions about your current gloves

  Yes No I am unsure
Do you believe your gloves provide adequate protection?
Have you ever had to modify your gloves?
Have your gloves ever failed to protect you?
Do you clean your gloves? If so, how?
Did you buy your own gloves?

Question Title

* 5. Indicate all of the threats and hazards that you have encountered.

Question Title

* 6. Rate each of the duty glove attributes in terms of how important the features are to you.

  Not important Somewhat important Very important N/A
Protection against cutting or slashing
Protection against puncture
Protection against needle stick
Protection against flame or heat (e.g., pyrotechnic or distraction devices)
Abrasion resistance
Tear resistance
Resistance to chemicals (e.g., riot control chemical spray)
Resistance to cleaning solution (e.g., bleach)
Ability to detect small objects (tactility)
Ability to pick up small objects (fine dexterity)
Ability to manipulate a weapon (e.g., press trigger, reload, clear malfunction)
Cold weather protection
Water resistance

Question Title

* 7. Rank each of the general glove features (1 is the highest rank and 5 is the lowest rank; CHOOSE EACH RANK ONLY ONCE)

Question Title

* 8. Do you believe there are trade offs for gloves between protection, durability, and fit/dexterity?

Question Title

* 9. Would you like to participate in the development of a standard on duty gloves? If so provide your contact information.

Question Title

* 10. Are there any features for your duty gloves not addressed above that you believe should also be considered as part of glove standard or specification.

T