Skip to content
Aircraft | Heavy Structures
Pre-Assessment
Complete this 3 minute pre-assessment and we'll contact you for next steps!
OK
*
1.
These are used to join together aircraft Sheetmetal structural parts:
(Required.)
Riveted members / Permanent fasteners
Stainless members
Steel fabrications
Assembled fabrications
*
2.
Using the hundredths ruler below, where is 0.95”?
(Required.)
A
B
C
D
*
3.
Using the hundredths ruler below, where is the 0.60”?
(Required.)
A
B
C
D
*
4.
What is the radius of a circle measuring at 5.500-inch?
(Required.)
1.375 inches
2.250 inches
2.750 inches
11 inches
*
5.
Hole size is determined by:
(Required.)
Minimum edge distance
Blueprint or manufacturing order
Engineering tolerances
All of the above
*
6.
If a pattern layout calls for “6 equal spaces” in a straight line, how many rivets will be installed on the line of fasteners?
(Required.)
5
6
7
8
*
7.
What is the missing dimension in Figure 8?
(Required.)
3.187
3.330
2.687
2.750
*
8.
The first step for removing a rivet with the rivet head in tact is:
(Required.)
Use the same size drill bit as the shank
Use rivet gun to shoot rivet back out
Use a drill bit that is one size Larger than the shank
Chisel the head off
*
9.
How many pieces 15/16-inch-long can be cut from strip of sheet metal 13 1/8 inch long?
(Required.)
10 pieces
18 pieces
5 pieces
14 pieces
*
10.
Which hand-held punch is used to mark points when laying out patterns on sheet metal?
(Required.)
Center Punch / Auto Center Punch
Draft Punch
Solid Punch
Hollow Punch
*
11.
Enter First and Last Name
(Required.)
*
12.
E-mail address
(Required.)
*
13.
Phone Number
(Required.)
*
14.
What is your preferred way of contact?
(Required.)
By email
By phone
No preference
Current Progress,
0 of 14 answered
