Polymeric Sand Quiz Question Title * 1. Email: Question Title * 2. Your Full Name: Question Title * 3. Polymeric sand is designed to set up hard like mortar. True False Question Title * 4. What type of fabric do we recommend using on a polymeric sand job? Woven Non-woven Either woven or non-woven Fabric should not be used on a polymeric sand job. Question Title * 5. Which of the following materials should not be used on a polymeric sand job? Concrete sand Clean chip Gator Base Stone dust Any of the above can be used on a polymeric sand job. Question Title * 6. Which of the following statements are not true about polymeric sand? It can be installed in rain or shine. It's designed to cycle from hard to soft. It can be installed in narrow joints. It requires compaction. Question Title * 7. Alliance-brand G2 polymeric sands do not need to be compacted. True False Question Title * 8. Polymeric sand should be installed at what height in the paver joint? 1/8" below the paver chamfer All the way to the top of the paver 2" Polymeric sand can be installed at any height. Question Title * 9. What is our recommended guideline for watering G2 Polymeric Sand? Working in 15 sf. increments for 30 seconds at a time Working in 30 sf. increments for 30 seconds at a time Starting at the highest point of the project and working your way down Using minimal water to avoid washing polymers out of the joints Question Title * 10. The very first thing you should do before installing polymeric sand is: Open all sand bags to check for clumping. Lightly mist the paved surface with water. Assess the job for moisture and potential water issues. Perform an efflorescence cleaning. Question Title * 11. The temperature should be above 32 degrees when installing polymeric sand. True False Question Title * 12. Polymeric sand may not activate properly if: Too little water is used There is pre-existing moisture on the job Watering starts at the top of the slope All of the above Done